T-Shirt Forums banner
1 - 4 of 4 Posts

· Registered
101 Posts
Discussion Starter · #1 ·
Got an abundance of Foam Truckers (all different colors and a ton of them) - not sure what else I can use to apply graphics to them?

I have tried sublimating them but either my image is not fully pressed on or if it does press on I get tape marks and stuff from the pressure being too high.

I tried HTV and same thing with the marks from the transfer sheet since the pressure is up.

I have glued patches on hats which is nice but kind of getting sick of that.

Any other things I should try out that I can do with these trucker hats?

BTW my hat press is not a good one and just a basic generic one with manual adjustments.

Any suggestions?
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.