T-Shirt Forums banner
1 - 4 of 4 Posts

· Registered
Joined
·
7 Posts
Discussion Starter · #1 ·
Hey guys,

I make hoods that button to collared shirts, just hoods. The hoods have two seams going down the back giving the hood three pieces (left, right, middle). Material is 100% cotton.

I have a very colorful design that I would like to design on all three panels of the hood. I've been told DTG / Sublimation is best to do this but will have to be done on the three pieces separately and then sewn together?

Does anyone have any information or experience with this? Any help is appreciated!

Below is a mock-up of what I'd like it to look like.

[media]http://cdn.shopify.com/s/files/1/0249/0050/files/Mock-Up-01.jpg?8763[/media]

Thanks!
 

Attachments

· Registered
Joined
·
7 Posts
Discussion Starter · #3 ·
Thanks!

I don't want to use polyester and I can't print it on the hood afterward because it definitely can't be completely flat. Are you saying that I can use DTG on cotton after the hood is already assembled?
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top