T-Shirt Forums banner
1 - 3 of 3 Posts

· Registered
Joined
·
210 Posts
Discussion Starter · #1 ·
Hi All,

I have a new cutter and I'm ready to cut some rhinestone templates. I have the mh365 cutter from us cutter and will be cutting on Hartco 425 material. I need to know the right settings to use. I am also wondering if it's supposed to be this difficult to get the vinyl under those little roller thingy's?
 

· Registered
Joined
·
1,027 Posts
Check to see if your pinch rollers, (the roller thingys) adjust. Hartco 425 is thicker that vinyl and they may need to be adjusted for thicker materal. Check your manual or call customer support.
 
  • Like
Reactions: tla1217
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top