Joined
·
3 Posts
I was fixing a registration error on a Mod One Y-Axis by opening up the Axis cover and tightening the three bolts that keep the two belts running in time.
I was sucessful at this, and started a test print to verify that I had fixed the registration issue before closing everything back up.
About half way into the print, the entire Y-Axis stopped working. No display activity, no up or down, no start or return on the platen. All the wiring appear intact, there red light that indicates a short is not beeping, and the 16 pin cable seems to be in good health.
Has anyone had this problem before? What was your solution?
I was sucessful at this, and started a test print to verify that I had fixed the registration issue before closing everything back up.
About half way into the print, the entire Y-Axis stopped working. No display activity, no up or down, no start or return on the platen. All the wiring appear intact, there red light that indicates a short is not beeping, and the 16 pin cable seems to be in good health.
Has anyone had this problem before? What was your solution?
