[creativeshirt]

Hello Need Expert Help. I am seeing bad nozzle check.. all my nozzles are kind of wavy .. See attached picture.. Not sure why.. The only thing recently i did recently was to replace the black ink cartridge...and drain the waste ink

 

[gatorGRAFIX]

Try doing a nozzle check with the platen all the way up in the 0 position and see if this helps.

Make sure that you do an alignment check also. Very simple to do. Alignment is the same for the F2000 and the F2100.

https://www.youtube.com/watch?v=8pjkcoU75a4

Usually most prints are done in the #2 position so if this works do the rest of your nozzle checks afterwards at the #2 height position and you should be good. I highly doubt that there is anything wrong with your printer. Judging by the 5 post count that you have I would guess you are a noob (which isn't a bad thing, duh! ). Welcome to fray and let us know if this has helped you out any. Good luck!!!