T-Shirt Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
Hi Everyone

I received my foison c48 cutter last week, It switches on and everything, and does a test cut (from the machine itself).

Problem is... In Artcut 2009 it does not pick up the serial port or usb.

I received a 232 serial port as well as a USB with it, manufacturer said that I must rename serial port COM12 to COM5. There my problems beign, It does not want to rename. I right click and go to properties but I can't see where to rename it.

Can I use only the USB or must I use both usb and serial por cable?
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top