New to forums. 
New to Creation cr630 (Runs straight usb)
Has anyone had any luck with setting up the cr630 using Mac Osx 10.5. and SigncutPro
Things i have done so far.
Installed SignCutPro trial. (Working)
Installed Drivers FTDIUSB For mac.
Cutter still doesn't show up in system profiler well it does but it says Communication Device. and i believe it should say FTDI. Would the Keyspan be a good idea? Work. or required. Any help would be much appreciated or anything i am missing?
Thanks.
New to Creation cr630 (Runs straight usb)
Has anyone had any luck with setting up the cr630 using Mac Osx 10.5. and SigncutPro
Things i have done so far.
Installed SignCutPro trial. (Working)
Installed Drivers FTDIUSB For mac.
Cutter still doesn't show up in system profiler well it does but it says Communication Device. and i believe it should say FTDI. Would the Keyspan be a good idea? Work. or required. Any help would be much appreciated or anything i am missing?
Thanks.
