Joined
·
1 Posts
When I turn on the Anajet Sprint my control panel flashes "Job ready load media" and "printer ready send print job" really fast. The wait light, power light and printer ready light also flash at the same time. I just replaced the Print Head Flex Cables on the printer.
I thought I have a job in the queue but there was nothing. It does the Power Up Sequence fine and moves the table forward. Then it waits just a few seconds and then the control Panel flashes “Job ready load media" and "printer ready send print job" really fast. It “Powers Down” just fine.
I restarted my computer. Power off the Anajet; disconnect the USB and the power wire, waited a couple minutes. It still does the same thing.
I cannot send a print job to the printer.
Please help.
Thanks Rebecca Richard
Performance Designs
[email protected]
423-413-3648
I thought I have a job in the queue but there was nothing. It does the Power Up Sequence fine and moves the table forward. Then it waits just a few seconds and then the control Panel flashes “Job ready load media" and "printer ready send print job" really fast. It “Powers Down” just fine.
I restarted my computer. Power off the Anajet; disconnect the USB and the power wire, waited a couple minutes. It still does the same thing.
I cannot send a print job to the printer.
Please help.
Thanks Rebecca Richard
Performance Designs
[email protected]
423-413-3648
