T-Shirt Forums banner
1 - 1 of 1 Posts

1 Posts
Discussion Starter · #1 ·
Wondering if anyone can help guide me in the right direction. I have an mp5i that will not print. I just got done replacing the main control board (with all the buttons and LED screen) after experiencing the “white light of death” I’m now able to get past the blue screen and fully boot up however it’s telling me my power voltages are out of tolerance and each value is 0V. (I was able to print properly prior to the white light) However on the printhead carriage board all voltage lights are lit green. The table and carriage head move and operate properly. I can pump fill and purge lines. I can’t nozzle check, I can’t print. I have attempted to calibrate head print voltage. I have spent way more time then bearable with anajet tech support.
Thanks in advance!
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.