[parkst23]

Anajet MP10i has bubbles in the white print head lines what do I do? I did a nozzle check and a printhead clean. Please help? I did just get this printer last night and I did drive 3 hours with it in my car last night and then plugged it in and let it sit over night. I am new with this printer and need some help. Thank you

 

[GetLost]

I assume you drove it back with machine filled with ink. Hope the print head carriage and table were secured.
Did you get the operations manual with unit?
How much bubbling is present? A picture would be helpful.
Nozzle check look good all the way across colors and whites?
Print line fill will force the air out. If the bubbles are at a minimum, load up a CYMK block pattern and print it several times to "Print out any problems".
I believe is what a tech stated...

Good skill with your machine.

Later.

 

[parkst23]

Yes I drove it with the ink in the lines. I did get all of the bubbles out of the lines today. I basically did what you mentioned above and everything is know working perfectly. Thank you for your advice.

 

[parkst23]

All fixed. All I had to do were a few 7 or 8 head cleanings and it fixed everything. Printer prints perfectly.