T-Shirt Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
4,664 Posts
There are no ink chips on the Anajet cartridges. They are the old Epson 3000 style cartridges and they have a white tab that sticks out the bottom of them. Here are some pics of what they look like. The picture with the small red square is where the bottom of the white L-shape tab comes out to tell you are out of ink. The other picture shows the rest of the L-shape tab that is glued to the ink bladder (which is glued to the other side of the cartridge). As the bag collapses as ink is removed, the white tab sticks out and hits an ink sensor. Pretty simple concept, but that is not the problem in this case. I would call Anajet Tech Support on Monday.
 

Attachments

·
Registered
Joined
·
4,664 Posts
Curt comes to the rescue! By the way, I check the user forum and Curt actually posted this solution about 8 months ago on www.AnajetUsers.com. See below. Nice Job and thanks for sharing.

Mark

---------------------------------------

Re: How to Reset Waste Ink Counter
« Reply #4 on: September 20, 2008, 04:43:35 PM »
--------------------------------------------------------------------------------
One thing that will cause the waste ink counter to keep coming up is that if the encoder strip is dirty or has some ink particles in it that will raise havoc with the waste ink counter. You will be having to reset this thing every day if not more. Simple to fix, moisten a large cleaning swab with cleaning fluid and run it the length of the encoder strip on both sides and dont get to rough with it since it is a very important peice. Than I took a soft paper towel and lightly pinched the encoder strip and wiped off the clean solution. it had a lot of black residue on the encoder strip. Fired it back up and hasnt had a problem in over 175 shirts now.

Put that tip on your list of things to check if you are having problems or under maintence.

prism
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top