T-Shirt Forums banner
Cancel

Anajet FP-125 Please Wait sytem initializing

[Anajet] 
Jump to Latest Follow
1 - 20 of 31 Posts
P

· Registered
Joined
·
67 Posts
Discussion Starter · #1 ·
I have now a second hand FP-125, but on the display stays "Please Wait system initializing and there is the power led is blinking.
At this moment i have NO computer on the system.
I turn on the powerknob on the backsite of the printer, after a few seconds on the display:Model FP-125 V5.41 Press power key. When i press on, the power key on the panel..."Please Wait system initializing". The printer stays in this stage.
What can i do?:confused:
 
23spiderman

· Registered
Joined
·
2,622 Posts
#2 ·
when i had this problem, it was because there was a job in the print queue, but you said no computer was attached...so i'm thinking to double check that all the ink cartridges are firmly in place. take them out and put them back in and make sure all the lights go off.
 
ironhog

· Registered
Joined
·
134 Posts
#3 ·
It makes me wonder if it is because the printer needs the drivers/software from the pc to complete the sequesnce. Short of that because there is no printer que my thought would be a dirty encoder strip..
Let us know what you do to fix this issue..
 
P

· Registered
Joined
·
67 Posts
Discussion Starter · #4 ·
Hello Ironhog,

i clean the encoderstrip, and try again to start, buth al is the same.
One notice, when i switch the power on (backside) after a few seconds i can move the table with the switch "table" on the front panel.

How can i check the encoder?
Have you some idea about the red leds under the cover?

Thanks for helping me.

Pierke:confused:
 
23spiderman

· Registered
Joined
·
2,622 Posts
#8 ·
mine isn't hooked up to my computer right now, and it's just fine. it still does it's auto maintenance (cleaning fluid installed) without a problem. it's possible that your control board has shorted out. AnaJet will replace this for free because they know it's a problem. you can still move the table when this happens. have you talked to the techs yet?
 
P

· Registered
Joined
·
67 Posts
Discussion Starter · #9 ·
Hello 23spiderman,
yes i can still move the table. I have not yet talked to the techs yet, must i take a ticket on the Anajet website? Replacing the motherboard?...i'am living in Belgium (EU) Dont now that they sended one to my.

Thank you,
Pierke
 
K

· Registered
Joined
·
215 Posts
#19 ·
Im still stuck with this error Anajet FP-125 Please Wait sytem initializing Im getting the red error light #1 on can anyone tell me what error light #1 reefers to, I've been out of servive for 2 months and now that I'm out of warranty I get no help from Anajet
 
1 - 20 of 31 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
About this Discussion
30 Replies
10 Participants
Last post:
Combojohn
T-Shirt Forums
A forum community dedicated to T-shirt merchants, professionals and enthusiasts. Come join the discussion about graphics, commerce, dyes, prints, collections, guides, displays, styles, scales, equipment, accessories, reviews, classifieds, and more!
Full Forum Listing
Explore Our Forums
Screen Printing General T-Shirt Selling Discussion Graphics and Design Help Member Introductions Heat Press and Heat Transfers
Top