[DBurke]

hi all!
i just replaced the print engine board (pcb) on my anajet fp-125 now the printer finally boots up normally, without the system maintenance loop, but now my computer dosent recognize the printer when i send a job to it ..all my anajet drivers are still installed on my computer. the computer says it dosent recognize the device, any ideas would be much appreciated..

 

[thedigiguy]

What version of windows are you using?

 

[DBurke]

I am using Xp

 

[thedigiguy]

From ek print does it show the Anajet driver or an Epson driver?

 

[DBurke]

under options I have an anajet still selected I wonder if I need to go into the Epson adjustmint program

 

[thedigiguy]

When you open the rip software ek print. What driver is it using?
Does it list Anajet as the selected driver? Do you see more than one Anajet driver?

 

[DBurke]

this happens as soon as I connect the printer to the computer with a USB the computer pops up a message that there is a device not recognized