T-Shirt Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
42 Posts
Discussion Starter · #1 ·
Has anyone here used the Aluminum Platens from Livingston Systems?

http://www.livingstonsystems.com/page8.html

They seem like a good idea if you do your curing on the platens with a flash dryer.

I have done only a few hundred prints and my Plastic laminate (over wood particle board) platens are beginning to show signs of warping. Needless to say, I am not very happy with the company that sold me my press.

-mrtshirtmaker
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top