T-Shirt Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
63 Posts
Discussion Starter #1
Hello. I have been doing alot of research on heat presses. Does anyone have a multiple heat press? I am low on funds and I am thinking that this would be the best way to go so that I can do more than just T-shirts. What do you think? I think that it would be cheaper to buy a all in one that to purchase each machine.
 

·
Registered
Joined
·
2,497 Posts
While your correct it would be cheaper, most of the all in one (or Swiss army knife) heat presses are of very low quality in a lot of cases there are trade offs to that type of press where it does a lot of operations but none of them very well.

Hope this helps.
 

·
Registered
Joined
·
8,082 Posts
I tend to agree with Jon.....and most of the all in one units have smaller platens on the press. Also you could not do what I was doing recently..doing a 50 mug sublimation order and pressing some plastisol on tees. Each mug was about a 5 min job..and during that time I could press three tees.. I think you should start slow with one type unit..press or mug press...and build from there..outsource until you make the $$ you need
 
1 - 3 of 3 Posts
Top