Made a post in the Direct to Garment (DTG) Inkjet Printing forum but it does not appear to be very active. I can take it down if needed.
I recently purchased a print shop that has a neoflex 2 in it. I was told on purchasing that the print head was bad and needed replaced. To verify this I went...
Does anyone know if it possible to just use a NeoSol as a NeoTex for dual CMYK just by flushing the inks and inserting the cartridges and a new head?
Just curious if there are any specific differences for the NeoSol in terms of software / firmware that might not let it use the NeoRip...
Right, so upon start up I instantly get the "NO MNT TANK" error message.
I have replaced:
Ribbon cables to tank sensor & sub board.
All Ribbon Cables from Sub Board to Motherboard
Pretty much all ribbon cables from motherboard to all other boards