Hi there! I have a Tajima TFMX-C1501 single head machine (2006 vintage) and I'm getting a Flash Design Read Error when I boot the machine up. Everything seems fine right up to the point where it would display the last design used on the display, I assume this design has gone corrupt and is...

Hello all - I run a very small DTG shirt printing business. I have a serious deadline and I need to get printing again by Wednesday. I just got an ambiguous error that says "Ink Pouch Error White 12" and the only thing I can find online is in the manual that says to replace the pouch. I cant...

Hi, we have a 16 head Happy embroidery machine, today it did something very strange for the first time. When running a design if needle 1-6 is needed, the needle bar will not move past needle 7/8. I have tried to manually move the needle bar selection unit and nothing is working, it wants to...

I have 3 toyota esp 9000's, about 3 weeks ago my building had a power surge while my store was closed and machines were off. I came in that Monday all machines turn on and 2 work fine but my 3rd will not receive designs. I use DataStitch Stitch pro. I have uninstalled the driver, switched...

Hi, Right, so upon start up I instantly get the "NO MNT TANK" error message. I have replaced: Ribbon cables to tank sensor & sub board. Tank Sensor Motherboard Sub Board All Ribbon Cables from Sub Board to Motherboard Pretty much all ribbon cables from motherboard to all other boards The...

I bought a Cutter Plotter iTransfer, it works when I used it to cut vinyl, but when I tried Contour Cut I can't used it... First I print, then I put the printed image on the cutter plotter, set the origin, and i press "Scan Marks" on the computer, after successfully scanning it I pressed OK to...

Hi everyone, in need of urgent help I have a inbro IB-TUN1204-45 Machine was working perfectly fine Today after a few embroidery jobs i inserted a floppy to load a new file. Kept getting critical error and so reloaded the design to floppy and inserted etc and end up using a different floppy...

Hello everybody! I hope you’re all well and succeeding in your creative endeavours! I’m new here so please bear with me. I have come into the possession of a PUMA III plotter and it seems to be in excellent condition other than I’m getting an error saying ‘rollers are up’. Can anybody help me...