T-Shirt Forums - View Single Post - [MOD-1 DTG] Print not holding up after one wash
View Single Post
Old June 6th, 2011 -   #10 (permalink)
Forum Member
T-Shirt Member
Thread Starter

VideoHQ's Avatar
You can call me: Betty
Member Since: Oct 2009
Posts: 17
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Thanks: 11
Thanked 1 Time in 1 Post

Default Re: Print not holding up after one wash

Originally Posted by JeridHill
If it's a plastic bottle, too many times they are too inconsistent. My advise would be to go to Home Depot or Lowe's and purchase a wagner spray gun with a dual tip. $60-$80 with consistent spraying. When you are finished, run water through it and you are set....
Will do! Thanks!
Do you think my curing times/temps are good?
I think I'll try different times/temps and give them a wash.