T-Shirt Forums - View Single Post - Expert ii 24 - incomplete/ unfinished cuts
View Single Post
Old September 21st, 2018 -   #5 (permalink)
T-Shirt Lover
T-Shirt Master

MadeDesigns's Avatar
You can call me: Tony
Member Since: Feb 2013
Posts: 349
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Thanks: 24
Thanked 29 Times in 28 Posts

Default Re: Expert ii 24 - incomplete/ unfinished cuts

Originally Posted by Reymond
What is your software for your machine? Remove this software and reinstal itl

In most cases this helps.

I can't see this working. Let alone A different plotter may be operating fine with the same software. Why have to re install and look for your serial number , etc.

I am having a similar problem on a ar-24 where the pressure seems not to increase. cuts are there sometimes light.

I figure its a $300 machine its served its duty. Ran over $25k of vinyl through it maybe that is the mile limit on it.