T-Shirt Forums - View Single Post - [DTG Brand] MH01 errors on M2
Thread: [DTG Brand] MH01 errors on M2
View Single Post
Old September 1st, 2018 -   #2 (permalink)
davecrocker
Forum Member
T-Shirt Member

davecrocker's Avatar
 
You can call me: dave
Member Since: Nov 2015
Posts: 19
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Thanks: 0
Thanked 0 Times in 0 Posts


Default Re: MH01 errors on M2

not sure if you fixed this...but the platen being ejected or similar could be the sensor at the back on the bed itself. cheap part but a pain!

i had a problem where the 1st pass was fine and then it wouldn't reload for the colour. i couldn't even move the drawer back as the machine was trying to push it out more. and yes i got an error as well. turned out to be that sensor.