T-Shirt Forums - View Single Post - [Flexi-Jet Model L] No nozzle check
Thread: [Flexi-Jet Model L] No nozzle check
View Single Post
Old August 22nd, 2017 -   #6 (permalink)
T-Shirt Lover
T-Shirt Fan

BQMatt's Avatar
You can call me: Matt
Member Since: Apr 2012
Posts: 83
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Thanks: 23
Thanked 15 Times in 13 Posts

Default Re: No nozzle check

I have never let one sit for too long and put it back in. My guess would be that it depends on how long it sits. You said that when you fill fluid in the capping station it is flushed thru with a clean. That usually means the capping station is good. But, I would check that the tubes are connected under the cap. The fluid could be just draining out during the clean rather than the pump pulling it thru. Also make sure that the printhead is sealing over the cap properly. If the printhead is not firmly mounted in the carriage then it is possible that it not able to form the proper seal to prime the printhead.
BelQuette Mod1 Direct to Garment Printer