T-Shirt Forums - View Single Post - Gcc expert ii error light indicator
View Single Post
Old June 16th, 2016 -   #6 (permalink)
Senior Member
Certified T-Shirt Junkie

freebird1963's Avatar
You can call me: Mark
Member Since: Jan 2007
Location: Florida
Posts: 3,050
Mentioned: 5 Post(s)
Tagged: 0 Thread(s)
Thanks: 162
Thanked 277 Times in 234 Posts

Default Re: Gcc expert ii error light indicator

The clip error is cuz your page layout is not set right. The cutter thinks that the graphic is bigger than the media to be cut on.
Since the other didn't give which lights are blinking no way to help them.
In Corel
Go to Printer Setup choose the GCC driver/printer
Go to page layout and choose get from printer. Now it will normally be like 47inches by 23 inches. Change the 23 to however wide your vinyl is. I normally measure from one roller to the other.
Make sure you select your entire graphic and hit F12 and had a hair line to it. W/o it it won't cut either.

Good Luck
*** SEMPER FI Devil Dogs ***