T-Shirt Forums - View Single Post - Issue with opaque chunk and rough texture prints
View Single Post
Old November 7th, 2015 -   #4 (permalink)
Fluid
TSF Veteran
Certified T-Shirt Junkie

Fluid's Avatar  - this member was voted Most Helpful Member during our Annual August Member Appreciation Month
 
You can call me: Richard
Member Since: Jun 2005
Location: Jacksonville, Florida
Posts: 5,044
Mentioned: 15 Post(s)
Tagged: 0 Thread(s)
Thanks: 65
Thanked 273 Times in 209 Posts


Default Re: Issue with opaque chunk and rough texture prints

Wilflex has the best inks on the market. Other s may say differently and everyone has their own opinion yet Wilflex will always be on the forefront of innovation within our industry.

e used Wilflex and Rutland inks then went strictly Wilflex. Check out Wilflex PolyOne & Nazdar. I would suggest seeing about getting some samples yet already know you will be much happier with the inks. They aren't cheap though yet worth every penny.

The "Chunk" look like you need to adjust your off contact and or mesh tension. Both those prints should be easily done with #156 mesh. The lower you go with mesh thte more ink your dumping on the shirt. Pretty much going against the soft hand everyone is striving to achieve.

The deurometer of your squeegee also plays a role.
 
The Following User Says Thank You to Fluid For This Useful Post:
87rx7chick (November 7th, 2015)