T-Shirt Forums - View Single Post - [DTG Brand] DTG Viper 2
Thread: [DTG Brand] DTG Viper 2
View Single Post
Old April 21st, 2014 -   #16 (permalink)
jessleek
Forum Member
T-Shirt Member
Thread Starter

jessleek's Avatar
 
Member Since: Apr 2014
Posts: 12
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Thanks: 0
Thanked 0 Times in 0 Posts


Default Re: DTG Viper 2

Just take a look at the pictures. Its not the shirts or the way we press. Our heat press is not one of these cheap crappy ones we spent a bit of money on it as we had informed ourself about this before. As you can see the fibres of the shirt after heat pressing are dead flat. On an inline the fibres never come up this bad its mainly on a two pass. The problem is consistent across a variety of makes of shirts and quality of them. We have tried FOTL, B&C and others and they all show the same problem as in the pictures! If our pre treat technique wasnt good then we wouldnt be getting even prints, which we do get! Its just the white spots and raised fibres AFTER printing.