Re: Double blinking red after print starts and print bed dies
According to our support department probably not a sensor issue. From what you posted could be the rails need to be lubricated or there is a bed motor issue. If you need more details please contact our support department.
_
April 26th, 2015 09:42 PM
printprintprint
Re: Double blinking red after print starts and print bed dies
Forgot to mention the error code is PF acceleration lock. Found a few threads about this but none really explaining how to go about fixing it. Any help is appreciated, thank you!
April 26th, 2015 07:26 PM
printprintprint
Re: Double blinking red after print starts and print bed dies
Hi everyone! I've run into an error that has stumped me...
The printer will turn on and move the bed around fine during it's warm up sequence.
I can move the bed back and forth (sometimes it sounds a bit slow/lethargic).
I have cleaned the rails, etc. to make sure that was not the issue.
When I start a print it loads the bed (sometimes only gets halfway to the load position and freezes) and then when it goes to print (the motion where the print bed moves back then forward to start the print) it dies and double red blinking errors.
My theory is sensors, as this is the same error you would get if a shirt got stuck and the bed could not move, etc.
Anyone have experience with replacing sensors or whatever may be causing this? Thanks.