P600. I have the Adjustment Wizard.
Printer flashes the Waste Ink Pad error, I do a "check" and they're at 95%. I run the "initialize" sequence, power off printer, power back up, run a "check" again and all are at 0%.
Run prints for an hour. Error pops up and shows at 96%. Run "initialize" again, shows 0%.
Run prints for an hour. Error pops up and at 97%. Same cycle.
Now error shows 98%.
Any ideas?
Printer flashes the Waste Ink Pad error, I do a "check" and they're at 95%. I run the "initialize" sequence, power off printer, power back up, run a "check" again and all are at 0%.
Run prints for an hour. Error pops up and shows at 96%. Run "initialize" again, shows 0%.
Run prints for an hour. Error pops up and at 97%. Same cycle.
Now error shows 98%.
Any ideas?