leahmunoz

Hello, I recently purchased a Roland GX-24 cutter and I am having problems with the contour lines. When I print my artwork and go to object and set my contour lines, it shows just fine. After printing, I place my piece into my cutter to cut. After taking my piece out the cut lines are about 1/4 inch lower than my artwork. What do I do to fix the problem?

Thanks

 

Reply With Quote

miktoxic

does the design fit within the registration marks?

 

Reply With Quote

leahmunoz

It took me a while to figure it out, about a whole day of playing around, but I changed the settings of the cropmarks on base y and x in the printing set up and now it is working fine.
Thanks for your reply.

 

Reply With Quote

BESSIE

I bought a roland gx24 vinyl cutter i have 32 bit windows vista it said it would work with my system well it does now when i tried to install the software i was getting a code 1045 it would not load i finally got this guy at roland and he told me to turn off the user control it loaded right away hope this helps someone

 

Reply With Quote