Discuss the various aspects of heat pressed vinyl transfers. Popular and new types of vinyl media, suppliers, vinyl cutters /plotters, press times, quality, how to instructions and more can be found in this heat press sub forum.
Designed by me (mostly, customer had a similar layout so I tweaked it). This gives those wanting to know about small cuts on a pcut, the small letters at the bottom are 1/8", talk about a pain to weed lol. BTW, the stripe at the very bottom is something I started doing to give the customer a guide for alignment, and it also helps the app tape to stick and not curl. There is a stripe at the very top also.
Re: Example of my work and small letters on a pcut
Thanks! Oracal 651 was the vinyl I used. I was using Calon 2 Series 5000, but it was a PITA to weed lol. I switched to the oracal, slightly more expensive, but weeds so much easier.
Re: Example of my work and small letters on a pcut
Quote:
Originally Posted by badaml
Designed by me (mostly, customer had a similar layout so I tweaked it). This gives those wanting to know about small cuts on a pcut, the small letters at the bottom are 1/8", talk about a pain to weed lol. BTW, the stripe at the very bottom is something I started doing to give the customer a guide for alignment, and it also helps the app tape to stick and not curl. There is a stripe at the very top also.
This is a discussion about Example of my work and small letters on a pcut that was posted in the Vinyl Cutters (Plotters) and Transfers section of the forums.
Example of my work and small letters on a pcut 
