Discuss the various aspects of heat pressed vinyl transfers. Popular and new types of vinyl media, suppliers, vinyl cutters /plotters, press times, quality, how to instructions and more can be found in this heat press sub forum.
Up to now, we've been having someone cut all of our vinyl. Now we're looking at buying a cutter. Mainly for signs and smaller vehicle graphics.
I'm going to look at a CT630 (used) tonight. Can anyone tell me what to look for and/or give a ball park price that I might offer? I know a new CT635 is $1495.
Up to now, we've been having someone cut all of our vinyl. Now we're looking at buying a cutter. Mainly for signs and smaller vehicle graphics.
I'm going to look at a CT630 (used) tonight. Can anyone tell me what to look for and/or give a ball park price that I might offer? I know a new CT635 is $1495.
It comes with software and a few rolls of vinyl.
Thanks!
have u checked out uscutterdirect?
they have ct630
DO NOT PAY $1400 for a CT630 / CR630. The Creation line of cutters operate well and are normally very cost effective. There are many online stores that offer them for under $500.
Last edited by Rodney; July 7th, 2008 at 10:22 AM.
Reason: removed self promotion as per forum rules
Indeed, that price is extremely steep. Shop around, and as Mark suggested, you should be able to find them for $500 or less. Some of the PCut's we sell go for far less.
Indeed, that price is extremely steep. Shop around, and as Mark suggested, you should be able to find them for $500 or less. Some of the PCut's we sell go for far less.
Good luck
yea, because i paid about 375.00 for mine that i got from uscutters and that's with shipping. of course i bidded on ebay, but that's aroung the average even from other ebay bidders that had one cutters from uscutters.
I recently purchased a CR630 from Cutterpros.com. The enclosed drivers seem to be incorrect. My software does not recognize the cutter. Does anyone have any suggestions?
I recently purchased a CR630 from Cutterpros.com. The enclosed drivers seem to be incorrect. My software does not recognize the cutter. Does anyone have any suggestions?
go here:uscutterforum.com u will find all the answers u need, if not just join and ask and someone will be eager to help u
Hi Folks,
I have recently purchased a PCut 730 (Kingcut ver), and I must say I am very pleased with the unit. Together with Flexcut software I am getting good results for Vinyl car signs and T shirt lettering. The setup was a bit tricky but after that was all done it is running very sweet. The unit price is very good value for a small home based business.
Brian
I recently purchased a CR630 from Cutterpros.com. The enclosed drivers seem to be incorrect. My software does not recognize the cutter. Does anyone have any suggestions?
The CR series is a different bird than the CTN series we offer. Not sure if you will be able to get much help through the USCutter forums for the CR series....
__________________
Ken Imes - Lead Technical Support
USCutter - www.uscutter.com
CT630 Vinyl Cutter 
Re: CT630 Vinyl Cutter 
