matt98

Hi Everyone! I'm new posting here, but have been lurking for quite a while and learning a LOT.

I have Spectra Reflect Plus and have a silly question about it.

This material has 3 sections:

-clear layer (this is on the side you lay face up on the plotter or face down on the substrate),
-the vinyl itself,
-then the thicker clear mylar that you obviously peel after pressing.

My question is: do you remove the other clear layer of film that is faced up (when in a plotter)? My other materials are only 2 layers (vinyl and mylar), but this has the third and I'm confused!

Thanks in advance!!

 

Reply With Quote

JoshEllsworth

Quote: Originally Posted by matt98 Hi Everyone! I'm new posting here, but have been lurking for quite a while and learning a LOT. I have Spectra Reflect Plus and have a silly question about it. This material has 3 sections: -clear layer (this is on the side you lay face up on the plotter or face down on the substrate), -the vinyl itself, -then the thicker clear mylar that you obviously peel after pressing. My question is: do you remove the other clear layer of film that is faced up (when in a plotter)? My other materials are only 2 layers (vinyl and mylar), but this has the third and I'm confused! Thanks in advance!!

Yes, you should remove the thin clear film prior to cutting. This is a protective layer only.

__________________
Josh Ellsworth -- Imprintables Warehouse -- 1-800-347-0068 x.236
Videos, Tutorials, Blog: JoshEllsworth.com - Exclusive T-ShirtForums Member Pricing

 

Reply With Quote