LockTee

Hello I have a pcut mh 721 se with 4 meg ram that I recently bought on eBay. I am starting out on a shoestring thus the reason for this purchase I need help adjusting my cutter to close cuts. The plotter seems to to cut good except that it is leaving random openings in both graphics and lettering. Just wondering if anyone could enlighten me as to how I can make adjustments to take care of this problem. I am also using a usb connection with the supplied roland 45 degree blade and Flexi pro 7.6. The plotter came bundled with Artcut but after reading many post's advising to stay away from I have not installed it. Any help or direction would greatly be appreciated.

Thank's in advance

Mike

 

Reply With Quote

COEDS

I would suggest you also might try to go to WWW.uscutter.com This is the site that's primary purpose is to support your cutter type. Good like. ..... JB

__________________
RIP: 1964 - 2008

 

Reply With Quote

LockTee

I think I may have narrowed down the problem it seems to be an issue with the start and end cut any suggestions?

 

Reply With Quote

txmxikn

Mike,
I was wondering how you are coming along with your cutter. I just found the PRo Cut brand cutters on ebay. They are basically the same machine as the US Cutter machines only under a different brand. It also looks like you get a better package through Pro Cut and it's a bit cheaper, however, US Cutter offers excellend support which I doube Pro Cut is able to offer.

 

Reply With Quote

plan b

Mike if you go to signs101 forum you can post there they are a big group and good people,, they can fix you up with the flexi cut problem.

Hope this helps

R.

 

Reply With Quote

plan b

Sorry didn't realize how old this thread is my bad.

 

Reply With Quote