Discuss the various aspects of heat pressed vinyl transfers. Popular and new types of vinyl media, suppliers, vinyl cutters /plotters, press times, quality, how to instructions and more can be found in this heat press sub forum.
Okay I have a roland 24 and when I print the reg mark and cut from there starting position my cuts are off. If before I print and cut go to the settings and move one reg mark then print it cuts just fine. The other question is In illustrator there is the little roland window and in that window there are reg marks what's the point. Do you need to line them up when you transfer them over to cut studio.
just looked and no thers not. Funny thing when it looks for the third mark it look high then needs to look lower...on the stock set-up
I had this same problem when I first tried this on my GX-24. The vendor suggested to make sure to check the box for "Fine Adjustment" on the printer setup dialog box. When I did this it corrected the problem. Also if you have a pen instead of a blade you can practice on plain paper without having to waste the more costly transfer paper.
Hope this helps. Good Luck.
I use coreldraw and cutstudio. not sure if this will apply with illustrator.
Last edited by alm_limited; November 18th, 2009 at 04:04 PM.
Roland 24 cutting funny 
