Six

hey guys,

been doing a few frames for a long time and now i think im happy to admit i have the hang of it.

problem #2.

when i try to make a print the first one is ok, if i try a 2nd print the frame had ink underneath it, ie its like it seaped from the first print and when i put the print down it blurs the 2nd print. (hope that makes sense.)

suggestions?

__________________
Rock on
6

 

Reply With Quote

SLGProduction

flash it, maybe. need some more info. are they the same colors? Whats your off contact at? what are the tensions of your screens. Are you using spray tac or tac paper? What angle is you squeegee? whats the durometer of the squeege? Its is sharp?

 

Reply With Quote

Six

ok, single color only,

off contact um... i have put a 20c piece away from the screen so about 3mm.

trension, couldn't tell you they are hand streched, but very tight.

spray tac

80 degrees

not sure what this means

sharp squeege,

hope that sheds some light.

thankyou.

__________________
Rock on
6

 

Reply With Quote

SLGProduction

you should sharpen your squeegee after almost every use. You can use a couple of pieces of sandpaper to do this. PM me if you want more info about it. There are different durometer is the hardness or softness of your squeegee. What you might think is real tight on your screens might not really be tight, but who knows without a tension meter. Like I said above if you have any questions just PM me. Hope some of this helps.

 

Reply With Quote