JDM

this is my first time printing on a shirt pocket. they are polos so i want to eliminate errors so i don't loose $.
i have been reading and a few people are recommending using a sleeve board. is this the best way?
could someone give me some step by step on how you do this? do i tack spray inside the pocket?
i will be printing on darks and need to flash, will the adhesive hold up to flashing inside the pocket?

thanks, justin

 

Reply With Quote

Squirts

Clamp on Pocket adapters are available from most suppliers... I Know Mt Pocono Screen Supply sells them... Chuck

__________________

 

Reply With Quote

Fluid

pocket printing is the same as regular placement prints. If you use your sleeve palette you will need to burn the art accordingly (upside down) as you load the pocket on the sleeve palette differently than a regular shirt load. Tack as you normally would with dark shirts.

__________________
Corel Tutorials
http://www.unleash.com/fluid/index.asp

 

Reply With Quote

mizi117

anyone have the tutorial with pictures show the steps by steps?

__________________

my t-shirt design

 

Reply With Quote