Need to Register?

thutch15 · October 28th, 2009

When I set the tension meter on the mesh and I am looking straight at the dial is the tension meter reading:

1. From left to right of the meter.
or
2. From behind to in front of the meter.

Thanks Troy

out da box · October 28th, 2009

behind and in front. In other words, parallel to your line of sight.

staned · October 30th, 2009

have you popped one yet? it will scare the crud out of you!

thutch15 · October 30th, 2009

Quote:

Originally Posted by staned


	have you popped one yet? it will scare the crud out of you!

haha...no not yet. I am using the shur loc panels and I got a 156 panel up to 50 newtons....got a little scared it was going to pop, but never did.

out da box · October 30th, 2009

It's hard to pop a newmann stretched mesh. I can pop a diamond chase mesh at 25 newtons, and warp the frame too.

John_Sheridan · November 2nd, 2009

Quote:

Originally Posted by thutch15


	haha...no not yet. I am using the shur loc panels and I got a 156 panel up to 50 newtons....got a little scared it was going to pop, but never did.

Great tension!
There's only two sounds that scare me now, a screen pop over 50 newtons and printing a platen loaded with adhesive.

Need to Register?

Resources

T-Shirt Sites

Basic tension meter question