gailevans

I just purchased a Roland EGX-350 engraver at the ISS Show in Ft. Worth that I will be getting this week. I plan to make some rhinestone transfers, but I believe that more profitable things can be done using this for engraving manufacturing nameplates, signs, etc.

Does anyone here know of a forum similar to this one where one can post for help, get ideas, etc?

 

Reply With Quote

AdriaticBlue

You may try signing up for the Roland User Forums, as there was a link to them on the Roland Desktop Engravers Resource site.

__________________
AB

 

Reply With Quote

gailevans

Thanks, I signed up and am awaiting approval. I couldn't figure out how to access the forum to just read posts without having to register.

 

Reply With Quote

hi-nrg-joe

Hi Gail,

I have an engraver, but I think it's quite different than the one you have. The forum I use for engraving, woodworking, etc is www.sawmillcreek.org

Here is the direct link to the engraver's section. Engravers Forum - Sawmill Creek

The people there are very friendly and helpful, just like the ones here. Hope you can find what you're looking.

 

Reply With Quote