darz1984

HI All,

I've got a major problem!!! I have 50 shirts to get ready for tomorrow. There are colour prints going onto dark shirts using my roland GX24 to contour cut around the logos.

However, when i started cutting them, i have noticed that the bottom of the logo is getting chopped off and the top has an extra white line around it, due to the positioning when cutting. Im using a Roland template to cut using corel X3. I did notice that after it reads the reg marks it is sitting slightly above centre on the bottom left reg mark. Should it be dead centre? If so how do i change it? My Base X is set to 5.0mm and Y to 5.6mm as in the instruction manual! And page settings as suggested

 

Reply With Quote