T-Shirt Forums - View Single Post

Captain_K · July 17th, 2008

I can't output anything to my cutter.

I'm using ROBO Master-Pro because it came with my Graphtec ce5000-60. I installed the software and have the cutter set up properly. It's connected via USB, and the computer recognizes the hardware device when I plug it in.

But when I try to output a design to the plotter there is none found. It says 'Install Drivers'. I thought I did this when I installed the software from the cd?

Help please.

July 17th, 2008	- #1 (permalink)
Captain_K Forum Member T-Shirt Apprentice Member Since: Jun 2008 Posts: 7 Thanks: 0 Thanked 0 Times in 0 Posts	Graphtec setup question I can't output anything to my cutter. I'm using ROBO Master-Pro because it came with my Graphtec ce5000-60. I installed the software and have the cutter set up properly. It's connected via USB, and the computer recognizes the hardware device when I plug it in. But when I try to output a design to the plotter there is none found. It says 'Install Drivers'. I thought I did this when I installed the software from the cd? Help please.
	Reply With Quote