dAi

Quote: Originally Posted by JoshEllsworth The process for the dark paper is different than the light. For the dark paper it is already two layers, so just print it then cut it - then weed away the excess. After all of the excess is removed, lay down the masking material onto your image(s). Now use a squeegee to press out all of the air bubbles. Now lift the mask up - it should have your design on it, ready to apply. For light colors, mask the sheet on the backafter it is printed and prior to cutting in order to make it two layers. Trim the edges so that the mask is about the same size as your transfer paper. Now cut it using the proper downforce -found by doing test cuts. Weed away the excess or if your design is simple and fully contained within on piece, just lift it off. Lay your printed design face down on the shirt and follow the heat instructions for the paper you are using. Should work - you must be missing a step???

I did exactly u are saying for darks

is just TTD Mask is garbage, plain and simple it's really low tack type

 

Reply With Quote