 Re: How do you align a logo above the pocket?
Just a follow up.
I got a 4.5" square piece of masonite and stuck it to the left pocket area of the platen with a few drops of hot glue.
I put the pallet spray on only the raised square. Anywhere else slows up the alignment.
I pull the shirt in place, line up the top edge of the pocket with the square and hold the corners in place with two fingers and put a little tension on the T and stick it in place.
I make the bottom of the design 1/2" above the top edge of the pocket.
Other than adjusting the off contact, it is a quick setup and easy to get the logo centered and aligned above the pocket.
I'll be able to pop the square off, but It works so well, I may just leave the platen on the shelf for the next pocket job. |