T-Shirt Forums - View Single Post - Bottom platen of heat press. rubber or metal?

COEDS · July 22nd, 2007

when you say the bottom is wrapped in vinyl could it be a teflon cover that is on over the rubber pad for protection? As far as adjusting the pressure, you can turn it all the way to the left and count the turns to the right untill you can;t turn any more and the half way number would be medium.I normally adjust by the feel of the handle when I pull it down. .... Good luck.... JB

July 22nd, 2007	- #8 (permalink)
COEDS TSF Veteran Certified T-Shirt Junkie You can call me: JB Member Since: Oct 2006 Location: OHIO Posts: 5,507 Thanks: 147 Thanked 407 Times in 389 Posts	Re: Bottom platen of heat press. rubber or metal? when you say the bottom is wrapped in vinyl could it be a teflon cover that is on over the rubber pad for protection? As far as adjusting the pressure, you can turn it all the way to the left and count the turns to the right untill you can;t turn any more and the half way number would be medium.I normally adjust by the feel of the handle when I pull it down. .... Good luck.... JB __________________ RIP: 1964 - 2008
	Reply With Quote