T-Shirt Forums - View Single Post

Basement Ink · April 25th, 2007

Hello Forum Friends,
I just finished my second big job (big meaning 80 shirts.) I was doing a single color design on the front and one on the back. The mesh I used for the front was a 110 and the ink was international custom color which was an avacado green.

Here's my beef. My prints aren't smooth. They are a little rough. Sometimes the thread shows through. I feel like my off contact is good and I tried different pressure on my strokes, but I always got the same results. I'm stumped. Any advice?

Basement Ink.

April 25th, 2007	- #1 (permalink)
Basement Ink Forum Member T-Shirt Member You can call me: Ben Member Since: Mar 2007 Posts: 10 Thanks: 0 Thanked 0 Times in 0 Posts	Just not happy with my final prints Hello Forum Friends, I just finished my second big job (big meaning 80 shirts.) I was doing a single color design on the front and one on the back. The mesh I used for the front was a 110 and the ink was international custom color which was an avacado green. Here's my beef. My prints aren't smooth. They are a little rough. Sometimes the thread shows through. I feel like my off contact is good and I tried different pressure on my strokes, but I always got the same results. I'm stumped. Any advice? Basement Ink.
	Reply With Quote