Leeboy

Hey Gang, was just wondering, is there a trick to getting pressure on the top part of the back of the shirt print. It seems the collar sort of gets in the way ,not allowing even pressure, only on the top 1/2 inch or so.....When i peeled the paper off, it wasnt getting enough pressure....Must be a easy solve, any ideas? Thanks in advance, Lee

 

Reply With Quote

Pwear

If you're pressing right near the collar and can't position the shirt so the collar hangs off the side of the press, try using a mousepad under the image that you're transferring to raise the shirt a little bit so the collar is not being pressed.

__________________
The proud owner of a full service print shop. Screen printing, vinyl decals, stickers, signs and banners, vehicle lettering and wraps, and more! Check out our blog too!

 

Reply With Quote

Tdecorator

You should try a heat-press with an airbag, Hauptseite

 

Reply With Quote

Trauma11

Dumb question, are both sides of a heat press heated?

 

Reply With Quote

BigBear

Quote: Originally Posted by Trauma11 Dumb question, are both sides of a heat press heated?

The top only, unless you buy a special press with top and bottom heat. You would not use that for heat transfers.

__________________
Jack - staff@alphasupply.com - Alpha Supply Company - Dye Sub Tips
Heat Press Equipment and Supplies - 1-800-908-9916

 

Reply With Quote