funkygator2

I am a newbie. I heat press 6 shirsts yesterday using two different types of paper. The first two that I did w/ jetflex came out ok, but the ones that were pressed w/ IW jet II did not come out at all. The transfer paper is now stuck on the shirt and in some of them the tranfer is not even on the shirt. I got confused between the two kinds on paper and ended up pressing the IW Jet II ones longer than I should have; however, the back on the tranfer does't not seem burned or over heated (not yellowish) - is there anything I can do at this point?

 

Reply With Quote

Jacki04255

I have found if you trim it up it comes off easier, and pre-heat your shirt. But I also have problems with the paper.. I set temp at 345

__________________
Jacki Hughes

 

Reply With Quote