GBoyd

Hi, I am new to the heatpress adventure and recently bought a second hand press. The rubber mat is missing and I have been trying to figure out what material I should use. As I am in New zealand, its a bit hard to source.

I can get:
silicone rubber> good to 210C very expensive
EPDM> good to 140C mid price
Neoprene> good to 120C very cheap.

At the moment I am just using a folded blanket and it seems to work fine, and does not get very hot.

Any advice much appreciated.
thanks
Garry Boyd.

 

Reply With Quote

COEDS

I would contact the manufacturer and find out the specs. Good luck. ..... JB

__________________
RIP: 1964 - 2008

 

Reply With Quote

plan b

Its just silicone foam,, comes in grey and red.

__________________
Authorized GCC, Winpcsign 2010, Stickyflock and Bella Rhinestones Distributor
http://www.heatpressvinyl.com http://groupdeals.heatpressvinyl.com

 

Reply With Quote

nativegraphics

I too am looking for a pad for my 2nd heat press it's like 15x15 and 1/2 inch thick. any hekp on where i could obtain this would be helpful.

 

Reply With Quote