ppalmernc

I did my first 2 color job with cad cut materials.
The first color was fine, however, the second color had some air bubbles under it. I wasn't expecting that. Only expect that with vinyl lettering.
I can't squeegie a shirt.
What is the answer?

Thanks

TeamWear Plus - Home

 

Reply With Quote

JoshEllsworth

Quote: Originally Posted by ppalmernc I did my first 2 color job with cad cut materials. The first color was fine, however, the second color had some air bubbles under it. I wasn't expecting that. Only expect that with vinyl lettering. I can't squeegie a shirt. What is the answer? Thanks TeamWear Plus - Home

What is the brand of cad cut that you are using?

__________________
Josh Ellsworth - Stahls' CAD-CUT Direct
Manufacturer Direct Heat Transfer Vinyl

 

Reply With Quote

ppalmernc

Quote: Originally Posted by JoshEllsworth What is the brand of cad cut that you are using?

Yours Josh,

ECO Film.
Maybe I applied using wrong times.

 

Reply With Quote

JoshEllsworth

Do the first color for a limited time.

Use 305 degrees for 1 or 2 seconds only at a medium pressure then hot peel.

Now, run the full application on the second layer (full 10 seconds). Make sure that the second layer is positioned completely flush when it is laid on the first layer.

__________________
Josh Ellsworth - Stahls' CAD-CUT Direct
Manufacturer Direct Heat Transfer Vinyl

 

Reply With Quote