Need to Register?

jlgill · March 28th, 2008

I've never used a dark shirt transfer, such as Ironall Dark.

Do you need a flash base when using Ironall Dark?

From reading posts in this forum, it seems like you are just able to print your design on the dark transfer paper and then heat press.

Any information on using this paper would be appreciated.

Thanks in advance.

mrdavid · March 28th, 2008

Print design on the paper with correct orientation (not as mirror image).
- Check printer settings; single-sheet feeding is recommended.
2. Cut Out Design
- Do not leave a margin around edge of heat transfer.
- Use an image with rounded edges to avoid corner liftoff after washing.
3. Peel Off Backing Paper
- This is done by slightly tearing backing paper of the heat transfer paper on edge of paper and gently peeling it away.
4. Preparing for Transfer (Heat Press Application Recommended)
- Prepare heat press at 350 degrees F.
- Place transfer paper with design facing upwards in desired position on fabric.
- Cover image with enclosed silicon paper (which can be used a couple times).
- Using above recommended temperature, apply firm pressure for 15-20 seconds.

Need to Register?

Resources

T-Shirt Sites

Flash base for Ironall Dark?