 teeth not showing up
I have a graphic I nabbed somwere off the net to play around with.
I traced it with potrace.
I have been fooling around with it in AI CS2.
I went to paths and had it clean up.
Somethings tho.
When I looked at it in outline mode there were lines were there was nothing in preview mode. That I don't get at all.
Second as I was deleteing what I assumed was "bad" lines to be cut by the cutter I delete 2 of the back teeth. I copied some other teeth and pasted back in. In outline mode they show. In preview mode they are not there. Totally confused on that.
I saved and opened in corel and same thing and the eye shows in AI but not corel in normal mode.
I can't upload the ai file but if anyone can look I can email it to you.
I am just lost.
Thanks
mark
__________________
SEMPER FI***Corel X4, PS CS3, GCC Bengal, CraftRobo, WF 1100, GX-7000, OKI C5500
Last edited by freebird1963; September 20th, 2008 at 01:31 PM.
Reason: poor grammar
| 
