JDM

i have my 1st pocket tee job this week. i was going to buy a pocket master attachment but my supplier was out and it would take 7-10 days to come in. so my question is can i make one? do any of you have one? can you post pics and measurements? i am printing white on black so i will have to flash and use 2 coats so i kinda need something to tack the pocket down to.

 

Reply With Quote

Almightees70

I just made a sleeve pallet out of birch, and then cut the end down to a width of about 3" to 3 1/2" and use that for any on pocket jobs I get. Hope this helps.

 

Reply With Quote

JDM

Did You Leave It 3/4" Thick?

 

Reply With Quote

Almightees70

Yes, It does make the fit of the pocket snug on the pallet, but works none the less. You just need to take my suggestion and revise it as needed.

 

Reply With Quote

JDM

i will give this a try and post my results. any other suggestions would be great. thanks, J

 

Reply With Quote