joeydgraffix

Ok, so I'm not sure if I need to use FastRip only to get the printer settings.

But when I use photoshop, when I go to advanced for Epson, I can't find the driver settings like 720dpi photo/cartoon settings etc.

Also, from photoshop, what type of settings do you use when you print on the shirt? cause I can't find any info???

 

Reply With Quote

lazographics

You need to actually select the fastt-jet printer and not the epson. If you don't see it what you need to do is in your fast rip go to Printers>Manage Printers and select control panel. Close that and it will update into your printers and faxes. No go to Photoshop, select your printer as the fastt-jet. Then go to page setup, then layout, and then the advanced tab at the bottom. This will allow you to select your paper size, Print mode, and underbase print mode. Then hit print and it will go to your Rip.

You will get a solid underbase and not be able to control it like you can in fastartist. Also, you can only print from photoshop properly if you are using the T-Jet 1 and T-Jet 2 only because of the page sizes. If you were using the Blazer it would be difficult because you work off of templates that you cannot select in the options. But, FastArtist 2.0 will allow you to print from the Blazer because the templates are now integrated into the software.

__________________
Billy
http://www.lazographics.com

 

Reply With Quote

joeydgraffix

Ahh ok, I will do all that and see what happens.

Yeah I had that problem, I did a 12 x 17 image that came out to 6x7 printed...but I'm finally hjappy that the printer is working and that the prints are coming out very sharp! I still need to try color prints though and other color shirts.

 

Reply With Quote